Avishek Das; Ajay Kushwaha; Nakul Raj Bansal; Vignesh Suresh; Sanghamitra Dinda; Sanatan Chattopadhyay; Goutam Kumar Dalapati
Abstract
In the present work, cupric oxide (CuO) nanoparticle (NP) thin films were synthesized on glass by combination of sputter and chemical bath deposition technique. The CuO seeds were deposited by using radio frequency (RF) sputter technique at room temperature. CuO nanoparticles were prepared by chemical ...
Read More
In the present work, cupric oxide (CuO) nanoparticle (NP) thin films were synthesized on glass by combination of sputter and chemical bath deposition technique. The CuO seeds were deposited by using radio frequency (RF) sputter technique at room temperature. CuO nanoparticles were prepared by chemical bath deposition. Effect of solute molar concentration (0.02 to 0.04M) and annealing temperature (at 400°C) on nanoparticles size and distribution were studied. The average size of nanoparticles is small in lower molar concentration, which is restructured after annealing to form dense film with relative smaller size nanoparticles. The work opens up new route to synthesize CuO nanorticle thin films for different applications.
Goutam Kumar Dalapati; Vignesh Suresh; Sandipan Chakraborty; Chandreswar Mahata; Yi Ren; Thirumaleshawara Bhat; Sudhiranjan Tripathy; Taeyoon Lee; Lakshmi Kanta Bera; Dongzhi Chi
Abstract
The structural defects and formation of native oxides during thermal treatment on p-type epitaxial-GaAs/Ge have been investigated using spectroscopic measurements and electrical characterization. The performance of epi-GaAs based device depends on the interface quality between epi-GaAs and gate oxide ...
Read More
The structural defects and formation of native oxides during thermal treatment on p-type epitaxial-GaAs/Ge have been investigated using spectroscopic measurements and electrical characterization. The performance of epi-GaAs based device depends on the interface quality between epi-GaAs and gate oxide and structural quality of the epi-GaAs layer. P-type epitaxial-GaAs was grown on Ge substrate using MOCVD technique at 675oC. Defective surface native oxides of arsenic and gallium oxides are observed for as-grown epi-GaAs layer. The arsenic oxide significantly reduced after thermal treatment as seen from XPS observations. The structural defects at surface enhanced after thermal treatment which is clearly probed by micro-Raman spectroscopy. Atomic layer deposited (ALD) Al2O3 significantly improved the interface properties after thermal treatment compared with bare epi-GaAs layer. Even though, the interface trap defect density slightly higher for p-type epi-GaAs MOS capacitor compared with bulk p-type GaAs devices, high frequency-dispersion in epi-GaAs based devices observed. This is mainly governs through the formation of p-i-n junction diode in the epi-GaAs layer on Ge substrates.
