Tirupathi Rao Penki; Brij Kishore;N. Munichandraiah; D. Shanmughasundaram
Abstract
Carbon has been prepared by pyrolysis of grated, milk-extracted coconut kernel at 600 ºC under nitrogen atmosphere. The disordered carbon has sheet like morphology. The carbon exhibits a high reversible Li + intercalation capacity in a non-aqueous electrolyte. The initial charge and discharge capacities ...
Read More
Carbon has been prepared by pyrolysis of grated, milk-extracted coconut kernel at 600 ºC under nitrogen atmosphere. The disordered carbon has sheet like morphology. The carbon exhibits a high reversible Li + intercalation capacity in a non-aqueous electrolyte. The initial charge and discharge capacities are 990 and 400 mAh g -1 , thus resulting in an irreversible capacity loss of 590 mAh g -1 . Nevertheless, subsequent discharge capacity is stable over a large number of charge-discharge cycles. The electrodes withstand charge-discharge currents as high as 1257 mA g -1 and they deliver discharge capacity of 80 mAh g -1 . Diffusion coefficient of Li+ obtained from galvanostatic intermittent titration is 6.7 x 10 -12 cm 2 s -1 . Thus the coconut kernel derived carbon is a suitable anode material for Li-ion batteries.
Yellareswara Rao Kosuri; Tirupathi Rao Penki; Munichandriah Nookala; Per Morgen; Mohan Rao Gowravaram
Abstract
LiCoO2 thin films used as cathode layers in thin-film solid-state batteries have been deposited from LiCoO2 powder target using radio frequency (rf) magnetron sputtering in a cost effective approach in terms of material consumption and processing time. X-ray diffraction (XRD) studies of the films after ...
Read More
LiCoO2 thin films used as cathode layers in thin-film solid-state batteries have been deposited from LiCoO2 powder target using radio frequency (rf) magnetron sputtering in a cost effective approach in terms of material consumption and processing time. X-ray diffraction (XRD) studies of the films after post deposition annealing treatment revealed (104) orientation, which is the characteristic of rf sputtered LiCoO2 films. Raman spectroscopy was used to identify the different modes of vibration of atoms in the film. The surface morphology and cross-section of the samples were characterized using field emission scanning electron microscopy (SEM). The chemical analysis of LiCoO2 thin films was examined by X-ray photoelectron spectroscopy (XPS) showed atomic ratio of Li/Co as 0.9 which is close to the ideal value 1. Electrochemical characterization such as charge – discharge and cyclic voltammetry were conducted for LiCoO2 films deposited on platinized silicon substrates in the potential range 3.0 to 4.2 V vs Li/Li + . The maximum discharge capacity of 64 µAh.µm -1 . cm -2 and 52 µAh. µm -1 .cm -2 were achieved when discharged at a current of 5 µA and 50 µA for the first discharge cycle respectively. Moreover the electrochemical investigations of LiCoO2 thin films on flexible copper substrates also investigated and achieved an initial discharge capacity of 83 mAh/g. The possible reasons for degradation in the electrochemical properties have been discussed. The present work indicates suitability of sputtering from powder targets for thin film battery fabrication.
